Welder Production I

About the role

This is a 2nd shift position.

Minimum Job Requirements

• Must be able to add, subtract, multiply and divide in all units of measure, using whole numbers, fractions and decimals.
• Must be able to read tape measure and blueprints.

Essential Job Functions

• Preheating and/or post heating of parts using proper preheating procedures and the use of temp sticks as well as inter-pass temperatures, as well as using required and furnished electrical and/or gas equipment and following prescribed or standard practices.
• Demonstrate a high degree of cosmetic acceptability in all welding operations.
• Read and interpret documents such as safety rules, operating and maintenance instructions and procedure manuals.
• Utilization of gas heating and burning equipment to cut and/or fit parts.
• Detection and reporting of defective material, faulty operations and unusual conditions to proper supervision and quality personnel.
• Pressure pipe welding in areas where required.
• Operation of machine assisted weld equipment in buildings where required.
• Maintain weld qualification by using the process at least once in a six month period.

Other duties as determined by supervision

Other duties as determined by supervision.

Working Environment

• The physical demands described are representative of those that must be met by an employee to successfully perform the essential functions of this job.
• Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions.
• This position is located on the production shop floor, in multiple buildings.
• While performing the duties of this job, the employee is regularly required to use tools or controls.
• The employee is frequently required to stand, reach, climb or balance; stoop, kneel, crouch, or crawl.
• Incumbent will work in a typical fabrication environment including the use of solvents, adhesives, hydraulic oil, petroleum products, etc.
• There is frequent lifting and/or moving of up to 50 pounds.

Education & Experience Requirements

• A High School diploma or General Education Degree (GED) preferred.
• Must be fully certified in the GMAW (mig) processes in the flat position welding (AWS D1.1).
• Certification for pressure pipe welding in areas where the process is part of the normal job duties.