Equipment Engineer, Wet Process

About the role

T1 Energy is bringing solar manufacturing back to the U.S. by building a domestic solar supply chain. Our mission is to invigorate America with scalable, reliable, and low-cost energy. Our fully operational 5GW solar module facility in Wilmer, Texas, can manufacture more than 20,000 modules every 24 hours. By the time you finish reading this paragraph, we will have produced two solar panels that will power American homes and fuel domestic AI. We're focused on building advanced American manufacturing and we're passionate about engineering a better future filled with abundant energy.

The Role G2 is T1 Energy’s new TOPCon solar cell fab in Rockdale, Texas. Every cell we make starts in wet process: texture, rear polish, and glass removal. When these tools stop, the fab stops. We’re hiring Equipment Engineers to keep them running. You’ll own a set of wet chemical tools, from install through high-volume production. The set covers batch texture, RCA-clean rear polish benches, and inline BSG and PSG removal strip tools. It’s a hands-on role: most of your day is at the tool, and you’ll be trusted to make the engineering calls that keep it running. This is an on-site role at G2 in Rockdale, Texas, day shift supporting a 24/7 fab, with an on-call rotation for critical tool-downs, and cleanroom and sub-fab work in full chemical PPE. You’ll be building a fab from the ground up: your PMs, your procedures, and your fixes become the standard, and the calls on your tools are yours to make.

Responsibilities

• Own OEE, availability, MTBF, and MTTR for your toolset.
• Be first on the tool when it goes down.
• Make it safe, diagnose the failed component, and restore it.
• When you escalate to the vendor, bring clear data.
• Close root cause on chronic failures, wafer breakage, and leaks using 8D, FMEA, and Pareto, and verify the fixes hold.
• Analyze alarm histories, maintenance records, and tool data in JMP, SQL, Python, or Excel to spot failure trends before they cause downtime.
• Own the PM schedule, refine vendor PM procedures, and set critical-spares levels, then adjust both from failure history.
• Keep interlocks, leak detection, and exhaust and scrubber interfaces working on tools running HF, NaOH, and HCl.
• You’ll do this together with EHS.
• Work with Process Engineering on bath life, chemical change-out, and concentration-control hardware.
• Bring tools through install, SAT, and qualification into production.