Brake Operator II

Summary of Responsibilities

This position is responsible for the complex set-up and forming techniques.

Responsibilities

• Accepts and follows priorities assigned by the Brake Lead.
• Run out set ups that have been proven, make changes in tooling and machine controller as needed to maintain tolerance on very specific dimensions.
• Set up most jobs given with little to no assistance.
• Maintain parts’ dimensional conformance using dial calipers, squares, protractors, height gauges and any other measuring tool required.
• Be productive with set ups, running parts, and know when to utilize assistance from entry-level operators as needed.
• Help lower level operators with set-up and measuring related issues when directed by the Brake Lead.
• Know, perform and complete Vander-Bend Manufacturing Set-Up sheets for every job when completed.
• Helps to keep Brake Department area clean and orderly.
• Other duties as assigned.

Requirements

• Minimum 2 years as a Brake Operator, with an additional 2 years related of other shop experience.
• Ability to read and write and understand written documents.
• Must visually know the difference between metals, such as aluminum and steel.
• Must know how to use dial calipers, squares, protractor and most any other measuring tool.
• Must know how to use a calculator, have basic math skills, such as addition subtraction, multiplication and division, and some trigonometry. Use of “k” factors and know how to figure a "k" factor. Use of shop math to perform simple to complex part “back-checks”.
• Must have good layout skills for forming as it pertains to form direction, angles and setting up.
• Must know third angle projection as it pertains to print interpretation, and understand print call outs, notes and some geometric tolerances.
• Must have good counting skills and keep accurate counts.
• Should have some computer skills and know the Amada 9-EX controller very well.