Precision Industrial Painter - 3rd Shift

About the role

Eaton’s AER FMC Fuel Motion Control Systems division is currently seeking a Precision Industrial Painter - 3rd Shift at our Euclid, Ohio plant. This is a third shift role, from 12am - 7am.

Responsibilities

• Follow print specifications and established operating procedures, perform a variety of operations to fabricate bearing assemblies and apply coatings to a variety of hardware.
• Perform visual and dimensional inspections and maintain accurate documentation on a variety of parts in accordance with ANSI Y14-5 and the certified operator program.
• Assistance may be given other operators on proper operational procedures.
• Perform preparatory work such as unpacking, visual inspection, degreasing, blasting, masking, plugging, and wrapping, etc., to screen surfaces for spray application according to blueprints, operational sketches, specification sheets, and tool lists.
• Mix spray compounds according to specifications. Prepare solutions, paying particular attention to volumetric, viscosity and specific gravity requirements.
• Clean, adjust and fill spray equipment. Check equipment for proper operation.
• On coatings requiring a drying or curing cycle, set oven, or other drying equipment controls to specified temperature and time.
• Apply coatings to specified thicknesses. Use electronic gages (such as Permascope) and other measuring/testing equipment as provided to determine if thickness meets specifications.
• Lap and/or ball burnish coated surface to bring into finished tolerances.
• Perform all post-operative work such as removing masks, tape and plugs and use solvent to clean up parts as required.
• Maintain component build records per government contract requirements.
• Handle all materials carefully. No open flame permitted.
• Operator must wear fume mask in posted areas.
• Move material within the cell.
• Chart, plot and react to data per SPC requirement.
• Load and unload Datamytes.
• Maintain accurate lot control (QCP 6.0) traceability, record keeping, log book entries, NCR’s (QCP 11.0) and associated documentation.
• May be required to perform more than one operation at a time as directed by the supervisor.
• May be required to burr work internal to the cycle.
• Perform sub-assembly work.

Requirements

• High school diploma or GED from an accredited institution.
• Minimum one (1) year of machining experience OR Minimum one (1) year of industrial painting experience.
• Reside within a 50 mile radius of Euclid, Ohio.
• Active Duty military are exempt from the geographical requirement.

Qualifications

• This position requires access to export-controlled information.
• To conform to U.S. Government export regulations applicable to that information, applicant must be a U.S. person, defined as a (i) U.S. citizen or national, (ii) U.S. lawful, permanent resident (green card holder), (iii) refugee under 8 U.S.C. 1157, or (iv) asylee under 8 U.S.C. 1158.