Pack Assembler

Specific Duties And Responsibilities

• To follow header schedule and make sure Formax machines have die packs ready for upcoming setups.
• This includes pulling the necessary job box, checking to ensure all tools are ready for installation.
• In accordance to the setup sheets, making sure all dies, spacers and loose tools are ready for proper station.
• Installing all punches, dies, fingers on transfers.
• Building cutter pack (changing the cutter and quill and setting the gap).
• Making needed settings to punch wedges, IFO timing On packs returning from heading the work is as follows:
• Pull and clean all tools in punch pack, die pack and transfer fingers.
• Review the progressions and last piece off to make sure all tools are still good and can be used on next run.
• If tools need replaced they are replaced at this time, and green card put on box and returned to shelf.
• If tools are not available then it is noted on the sheet and the red card is displayed to show we lack tools.
• Once tooling is taken care of then punch block and die block and IFO are cleaned and readied for next setup.

Safety

• Maintains safe and clean working environment by complying with procedures, rules, and regulations
• Follows all safety requirements to avoid injury to self and fellow employees
• Create and maintain a safe work environment; repair and/or report non-conformances to company safety policies and guidelines
• Perform the necessary safety requirements to avoid injury to self and fellow employees

Work Environment

• Clean, professional, well-kept manufacturing plant
• Non air conditioned environment

Physical Demands

• 80% of the time standing
• Will require walking and standing as well for 10 hr. shift
• Lifting, pushing, or pulling of up to 40 lbs. regularly
• Attention to detail is required

Position Type/Expectations Of Working Hours

• Hourly position
• Monday through Friday, minimum 8 working hours daily
• Occasional Saturday when necessary