Machine Parts Inspector A 2nd shift (MTC)

Responsibilities

• Visually examine machined parts and use precision instruments, gauges, etc., to verify adherence to blueprint specifications, workmanship standards, material, and finish (excluding gears and gear‑type parts).
• Create complex layouts and setups on a surface plate, checking measurements to close tolerances.
• Inspect parts made from various grades of steel, aluminum, aluminum alloy, brass, bronze, as well as bolts, die castings, sand castings, forgings, extrusions, purchased parts, brake cylinders, oleo struts, etc.
• Determine appropriate inspection procedures, devise methods for new machine parts, and recommend improvements to procedures and practices.
• Assign duties to lower‑grade Machined Parts Inspectors, instruct them in inspection methods, and review their work for accuracy and completeness.
• Participate in all phases of machined parts inspection in Receiving Inspection, including acceptance of vendor‑made machined parts, forgings, and castings (excluding gears), using layout or other inspection procedures.

Tools & Equipment Used

• Inspector’s hand and marking tools
• Machinist’s hand tools
• Precision‑measuring instruments
• Special testing and alignment devices
• Special precision gauges, templates, and material testing equipment

Requirements

• 36 months of machine shop practice or machine shop inspection experience, preferably in the aircraft industry.
• Eligibility to work with information subject to the International Traffic in Arms Regulations (ITAR); all applicants must be U.S. persons as defined by ITAR (U.S. citizen, U.S. permanent resident, political asylee, or refugee).

Additional Information

Location: Fort Worth, Texas, USA

Schedule: Full‑time, Second Shift (On‑site)

Job Level: Individual Contributor

Job Type: Experienced