Hardware Engineer Mid.

US Citizens or Green Card Holder Only. No C2C or 3rd Parties.

About the role

This is a 6-month contract position working onsite in New Freedom, PA. The role involves performing component-level diagnostics, root-cause analysis of PCBAs, and system isolation for motor/compressor drives, chiller control loops, and industrial protocols.

Responsibilities

• Diagnose and root-cause analyze failed PCBAs to component level.
• Isolate and troubleshoot complex system faults in motor/compressor drives, chiller control loops, sensor I/O modules, and industrial protocols.
• Conduct bench testing with oscilloscopes, multimeters, signal generators, power supplies, and thermal cameras.
• Perform hand-soldering, SMD/thru-hole replacement, and trace repairs.
• Document failure trends, track root causes, and write corrective action reports.

Requirements

• Bachelor’s degree in Electrical Engineering or related field.
• 5+ years of experience in hardware engineering and PCB design.
• Proficiency in component-level diagnostics and root-cause analysis.
• Strong knowledge of power electronics.
• Experience with oscilloscopes, digital multimeters, signal generators, power supplies, and thermal cameras.
• Skilled in hand-soldering, SMD and thru-hole repair, and trace repair.
• Familiarity with industrial communication protocols such as Modbus and CAN bus.
• Ability to isolate and troubleshoot complex system faults involving motor/compressor drives, chiller control loops, and sensor I/O modules.
• Proficient in documenting failure trends and writing corrective action reports.

Pay

Up to $42/hour W2 based on skill set and location.

Benefits

• Medical, dental, and vision benefits.
• Direct primary care benefits.
• After six months of employment, a 4% matched 401(k) plan with immediate 100% vesting.

Schedule

6-month contract, onsite in New Freedom, PA.