Electronic Assembler (QC & SMT Touch-Up)

Job Requirements

• Finished Board Inspection (QC): Inspect completed PCBAs for workmanship, component placement/polarity, solder quality, and overall completeness using work instructions, checklists, and visual aids.
• SMT Touch-Up & Minor Rework: Perform precise touch-up of small SMT parts (e.g., resistors/capacitors/diodes/ICs) including alignment correction and limited component replacement.
• Defect Identification & Documentation: Identify, document, and communicate defects and trends (e.g., missing/misaligned parts, solder bridges, lifted pads) and disposition boards per established procedures.
• Process & Work Instruction Adherence: Follow build documentation, QC criteria, and revision-controlled instructions; ensure proper ESD handling, labeling, and status of product throughout inspection and rework.
• Functional Testing: Run diagnostic tests on completed boards using multimeters or automated test fixtures to verify electrical performance.
• Chip Programming: Load firmware onto microcontrollers using specialized programming hardware.

Qualifications

• High School diploma or equivalent required; technical training or electronics certification preferred.
• QC/Inspection Experience: 2+ years of experience inspecting electronic assemblies/PCBAs, using workmanship criteria and checklists to identify defects.
• SMT Touch-Up Skills: Demonstrated ability to perform careful touch-up/rework on small SMT components and fine-pitch parts (lead-free experience preferred).
• Documentation & Traceability: Comfort working with basic computer tools to record inspection results, track board status, and interpret pass/fail outcomes where applicable.
• Attention to Detail & Dexterity: Strong hand-eye coordination for working with miniature components and consistently meeting workmanship standards.
• Ability to work independently and as part of a production team.