Gear and Shaft Machining- 2nd Shift

About the role

Eaton’s AER FMC Fuel Motion Control Systems division is currently seeking a Gear and Shaft Machining- 2nd Shift at our Euclid, Ohio plant. This is an onsite role, with core 2nd shift hours between 3:30pm - 12am Monday - Friday.

Responsibilities

• Set up and operate various drilling, milling, edge breaking, and burring machines to generate rough and finish dimensions on a variety of parts.
• Perform operations required to burr, polish, finish, and blend surfaces on machined parts.
• Perform visual and dimensional inspections and maintain accurate documentation on a variety of parts in accordance with ANSI Y14-5 and the certified operator program.
• Assistance may be given to other operators on proper operational procedures.
• Setup and operate super finish, lapping, center grinding equipment, balance, shot peen, edge breaking, sand vapor blast and burring machines to generate rough and finish dimensions on a variety of parts.
• Mount and accurately align various jig and fixtures, select speeds, and feeds.
• Load and align tooling, working from engineering layouts.
• Adjust stops and cams to produce finish dimensions to close tolerances.
• Utilize in-process gaging such as indicator arrangements, travel dials, etc., to ensure accurate size control.
• Read and interpret moderately complicated blueprints and execute quality checks using a variety of mechanical and electronic gages.
• Perform degrease and oiling operations on hardware.
• Set up and operate all equipment with minimum assistance, be familiar with work procedures involved with lapping, sub-assembly, balancing, super-finish, mill, drill and burring operations.
• Frequent changes in set-up and maintenance of close tolerance require constant attention.
• Maintain accurate lot control (QCP 6.0) traceability, record keeping, logbook entries, NCR’s (QCP 11.0) and associated documentation.
• Final stocking operations for completed product as required.
• Maintain clean equipment and work area.
• Move material within the cell.

Qualifications

• High School Diploma or GED from an accredited institution.
• Active Duty military are exempt from the geographical requirement.
• This position requires access to export-controlled information.
• To conform to U.S. Government export regulations applicable to that information, applicant must be a U.S. person, defined as a (i) U.S. citizen or national, (ii) U.S. lawful, permanent resident (green card holder), (iii) refugee under 8 U.S.C. 1157, or (iv) asylee under 8 U.S.C. 1158.
• Minimum two (2) years of machining (Non-CNC acceptable).
• Minimum 2-year GD&T Experience (successful completion of Eaton Level 1 Advanced Training will be considered in lieu of this requirement).
• Pass an Eaton vision test.
• Become a Certified Operator.
• Perform 5S and other duties as assigned.
• Complete Basics of Measurement courses: Blueprint Reading 131 Math Fundamentals 101 Math: Fractions and Decimals 111 Units of Measurement 112