Electronics Technician 3

About the role

Parsons is seeking an experienced Electronics Technician III to support the Federal Aviation Administration (FAA) under the TSSC-5 contract. This position involves performing installation, modification, testing, troubleshooting, repair, and preventive maintenance on electronic systems and equipment that support the National Airspace System (NAS). The role requires working under limited supervision, following established procedures, technical documentation, and FAA directives. The technician may work independently on routine or moderately complex tasks and supports senior technicians or engineers on more complex systems and activities.

Responsibilities

• Perform installation, relocation, and removal of electronic systems and equipment, including:
  • Navigation aids (NAVAIDS)
  • Communications systems (VHF/UHF, data/voice)
  • Surveillance and support systems
  • Associated power, grounding, and control equipment
• Troubleshoot and repair systems to the unit, board, or module level as assigned:
  • Use standard test equipment (digital multimeters, signal generators, oscilloscopes, etc.)
  • Follow step-by-step troubleshooting guides, fault isolation procedures, and technical manuals
  • Escalate complex or recurring issues to crew lead, FAA counterparts, and project management
• Read and work from:
  • Schematics, wiring diagrams, and interconnect drawings
  • Equipment manuals, technical orders, and job plans
  • FAA orders, work instructions, and site-specific procedures
• Assist in field installations and site work under TSSC-5:
  • Support pre-installation checks and site preparation
  • Install racks, cabinets, and equipment per drawings and installation standards
  • Route, terminate, label, and test cables (coax, fiber, copper) under guidance
  • Assist with system power-up, basic alignment, and functional testing
• Use and care for test and measurement equipment:
  • Configure and operate standard electronic test instruments
  • Perform basic measurements, alignments, and performance checks
  • Maintain proper calibration and handle equipment in accordance with procedure
• Document work activities in accordance with contract and FAA requirements:
  • Complete maintenance logs, service tickets, and test forms
  • Record parts used, corrective actions taken, and test results
  • Provide redline/as-built information to senior technicians or engineers
• Follow all safety, security, and quality practices:
  • Comply with FAA and Parsons safety policies, OSHA regulations, and site Risk Management Plans
  • Adhere to physical and information security requirements at FAA facilities
  • Follow configuration control and quality assurance procedures
  • Collaborate effectively with senior technicians, engineers, project managers, and FAA representatives to support project objectives

Requirements

• High school diploma is required
• May require repetitive movement such as lifting up to 50 lbs., bending, and standing
• Basic Microsoft suite and Internet, and E-mail
• Must be able to meet customer security requirements. A background check by federal authorities will be performed
• Must be able to travel up to 100% within the USA

Qualifications

• Five plus years of working knowledge of:
  • Basic analog and digital electronics
  • Fundamentals of RF and communications equipment
  • Use of standard electronic test equipment (DMMs, basic scopes, signal generators)
• Ability to:
  • Read and interpret basic schematics, wiring diagrams, and technical documentation
  • Follow written and verbal instructions and standard procedures
  • Work safely in field, shop, and facility environment

Security Clearance Requirement

None