Defense Machinist III Thread Grind 2nd Shift - Monroe, NC

BASIC FUNCTION

Finish grind threads on all rotors to size, index, form, and finish as required. Drill axial hole, cutoff, and counterbore as needed. Grind end faces on idlers.

EQUIPMENT AND TYPICAL PARTS

• Operate one, two or more machines including NCTG, CFG, Cutoff, test stands, DHD, etc.
• Use precision measuring equipment, such as micrometer, dial caliper, profilometers, lead checker, gash gauges, master, etc. to inspect rotors.
• Operate electric or air-powered crane/forklift.

Essential Physical Tasks

• Lift/pull/push.
• Continuously walk or move from one machine to as many as five.
• Physically, load and unload parts up to 40 pounds.
• Debur utilizing file or other hand tool such as die grinder.
• Clean parts and centers of chips and wipe dry.
• Physically, lift and check all dimensions machined to conform with finish drawing.
• Adjust machine as needed to produce quality parts within specifications and standards given per part.
• Utilize multi-function electric or air-crane (where available) to lift/move/load/unload parts to perform work center function.
• Step-up to and down from elevated work platform and on to various parts of machine for wheel change, tool change, and cleaning.

STATUS AND SCOPE

With own judgement and minimal direction from others, produce a quality ground rotor in a safe and efficient manner. Grind threads on all rotors-inspect sizes, index, form, lead, finish, etc. Deburr all sharp edges as needed. Check pump parts for burrs and fits. Assemble per assembly drawing. Test per specifications.

Minimum Education Required

• High School Diploma or equivalent.
• Machining Trade School preferred and one to three years machining experience preferred.
• Must be able to read blueprints.
• Use of advanced trade mathematics, reading complicated drawings, specifications, charts, etc. preferred.

Additional Qualifications/Responsibilities

• Certificates/Security Clearances/Other (Enter Below)

CANDIDATE REQUIREMENTS

• Education & Experience: High School Diploma or equivalent. Machining Trade School preferred and one to three years machining experience preferred. Must be able to read blueprints. Use of advanced trade mathematics, reading complicated drawings, specifications, charts, etc. preferred.

Job Category

Engineering

Affiliate Sponsor

Circor

Salary Range

Not Disclosed