Coatings Processor - C 2nd Shift (onsite)

About the role

Pratt & Whitney is seeking a Coatings Processor C for their C 2nd Shift position. This role is located in East Hartford, CT and is considered safety sensitive due to its location with the FAA.

Responsibilities

• Plan and perform pre and post coating operations on production, overhaul or developmental parts.
• Work from verbal, written and electronically generated instructions to set up, adjust and operate a wide variety of manual and numerically controlled auxiliary equipment in support of coating operations.
• Assist others responsible for new part process tryouts, run test pieces and re-operate rejected parts, following prescribed repair instructions.
• Check work both visually and with gauges provided.
• Assist others responsible for the setup, operation, changeovers and maintenance on a variety of complex coating equipment.
• Perform masking and de-masking operations; assemble and remove parts into holding fixtures.
• Clean out coating chambers during changeovers; clean and make minor repairs to fixtures, such as removing and replacing broken bolts or details.
• Perform routine servicing throughout the assigned area following specified procedures and written instructions (such as operator’s checklist).
• Refer difficulties to leader or supervisor.
• May be assigned to carry out tasks, not specifically listed, within the scope and skill level of this job description in support of department objectives and to develop individuals' skills.
• May be required to train for, obtain and maintain licenses, operator permits and certifications within assigned area.

Qualifications

• HS Diploma or equivalent
• Six months manufacturing/Industrial/Aerospace experience

Preferred Qualifications

• In compliance with the collective bargaining agreement, priority consideration is given to candidates who are INTERNAL (and recall) to the Pratt & Whitney IAM Bargaining Unit members of District Lodge 26 and Affiliated Locals 700 and 1746 (Connecticut Operations).
• Bachelor’s degree in engineering or graduation from certified program
• Minimum 2 years coating experience
• Minimum 2 years’ trades experience