CNC Ring Mill Operator - 2nd Shift

Your responsibilities

• Through continuous monitoring and measurement, assure that all products meet or exceed the customer expectations and assure compliance with all procedural requirements.
• Check work order for proper number of pieces, size, etc.
• Set machine for proper diameter, height, etc.
• Through the use of buttons, levers and switches, operate rolling mill to roll glowing billets into rings and other parts.
• During rolling process adjust radial and axial pressure as necessary.
• Observe rolling process and instruments and make adjustments as necessary to prevent parts from becoming out of round or wavy.
• Reroll ring, if necessary.
• Complete in-process inspection reports, etc.
• Make minor repairs and adjustments as required.
• Assist Maintenance in rebuilding the rollers and making other repairs to rolling mill.
• Keep working area in a clean, safe and orderly condition.
• Directs & assists mill helper in changing tooling on mill.
• Directs mill helper as to method of removing scale from face of each ring or part.
• Directs mill helper as to the amount of water to use when rolling a ring so equipment does not over heat, but does not use an over amount to cause ring or part to become too cold or cause cold corners.
• Directs mill helper in proper gauging procedure.
• Directs manipulator & crane operators in proper loading & unloading pieces on mill.
• Reports to foreman or ring engineering of any adjustments to blank that are necessary to assure good quality rings.
• In absence of either or both directs press operator to make adjustments.
• Perform other duties as assigned by supervisor.

EXPORT CONTROL

This position requires access to export-controlled technical data or technology. Employment is contingent upon thyssenkrupp's ability to obtain any required export authorization from the appropriate government agency or agencies.